Togu Audio Line - All Plugins Bundle VST, AAX, AU WIN.OSX x86 x64 [2016] [+Exclusive]

Commercial Products :
TAL-Sampler - $60
TAL-Bassline-101 - $102
TAL-U-NO-LX - $135
TAL-Sampler v1.8.1 :
TAL-Sampler is not just a sample player. It's a full featured analog modeled synthesizer with a sampler engine as sound source, including a powerful modulation matrix and a high quality self-oscillating 24/12/6 dB low pass filter.
TAL-Bassline-101 v1.7.1 :
TAL-BassLine-101 is a monophonic bass synthesizer and a very accurate emulation of the popular SH 101. The GUI is intuitive and easy to use. It produces the raw sound you know from analogue devices without any effects.
Its 24dB zero feedback delay low pass filter has a very smooth and authentic sound without any digital artifacts, especially designed and calibrated for extreme settings. It sounds even smooth with a lot resonance and a high oscillator pitch where most emulations fail.
TAL-U-NO-LX v2.8.0 :
TAL-U-NO-LX is a complete rewritten emulation of the popular Juno 60 with a new engine and GUI. Up to date zero feedback delay filters and carefully calibrated controls make this synth a good replacement for the analog device with all the advantages software plugins have. As an addition, the TAL-U-NO-LX also supports portamento and different filter LFO waveforms and some more useful features. An arpeggiator with different sync modes and hold function is also included. A very fast envelope with a smooth roll-off, emulated inaccuracy and a very smooth filter sound gives this synth the typical sound. The synth was calibrated after a hardware device that's property of TAL.
Free Products (FX):
TAL-Bitcrusher v1.0 :
TAL-Bitcrusher is a common bitcrusher with some useful additions. There is a low- and highshelf EQ and a noise cross modulator included. Its maybe useful on drums, especially hats and for distorted leads.
TAL-Filter v1.60 :
TAL-Filter is a free Multi-mode filter plug-in.
TAL-Filter-2 v1.25 :
TAL-Filter-2 is a host synced filter module with different filter types, panorama and volume modulation possibilities. The device includes all 4x oversampled TAL-NoiseMaker filters: LP 24 dB, LP 18dB, LP 12dB, LP 6dB, HP 12 dB, BP 12dB, N 12 dB. Its possible to saturate / distort the input signal by raising the input volume with the input control (only if you use a filter as modulation type).
Its also possible to modulate the panorama or volume of an incoming signal. This can be used for tremolo or trance gate effects. Panorama modulation maybe is useful to pan your percussion, hats or sound effects in the stereo room for more interesting rythms and sounds.
TAL-Flanger v1.0.0 :
TAL-Flanger is a easy to tweak stereo flanger effect with its own special sound and some asymmetric analog like components in the feedback corner. Useful for a wide range of flanger effects from subtle to extreme.
TAL-Chorus-LX v1.2.0 :
TAL-Chorus-LX is a 1:1 standalone version of the chorus implemented in TAL-U-NO-LX.
TAL-Dub v1.1.2 :
TAL-Dub is a vintage style delay effect. It can be used for a wide range of delay effects from clean to extreme distorted, resonating never ending delays.
TAL-Dub-2 v1.7.1 :
TAL-DUB-II is an extended version of TAL-Dub-I with a completely new sound engine. A 4x oversampled distortion stage allows to add vintage distortion to the delayd signal, but its also possible to make clean delays.
A sinus LFO has the possibility to modulate delay time and low pass filter cutoff. Adjustable LFO stereo width is also included.
An analog sounding 6dB low pass filter with resonance and a 3dB high cut filter are also parts of TAL-DUB-II. Different routing options open a wide range of possibilities.
TAL-Dub-3 v0.95b :
TAL-DUB-III is an easy to use delay device with some special features. Its no tape delay emulation and has its own sound. It has an alias free saturation stage, a non-linear 6dB low pass and a 3dB high pass filter that are included in the feedback path of the device. An input drive knob allows to adjust the saturation level. Pop-up menues show the current values of volume, delay-time and feedback knobs. A tab button allowing to adjust the delay time for live sessions.
TAL-Reverb v1.20 :
TAL-Reverb is an retro reverb recreation.
TAL-Reverb-2 v1.61 :
TAL Reverb-II is the most popular TAL-Reverb. After some user feedbacks had to release TAL-Reverb-II again. It combines the retro sound of TAL-Reverb-I with additional features. Version 1.61 has some small improvements in the internal modulation algorithm.
TAL-Reverb-3 v0.96 :
TAL-Reverb-III is an easy to use stereo plate plugin.
TAL-Reverb-4 v1.2.0 :
TAL-Reverb-4 is a standalone version of the high quality reverb implemented in TAL-Sampler.
TAL-Tube v1.0.0 :
TAL-Tube is a saturation plugin that have the characteristic of tubes and an additional amplifier mode. It's very suitable for adding higher harmonics and can give more excitement and analog character to digital sounds or drums. At extreme values it can also be used as a grungy distortion effect.
TAL-USE v1.0 :
TAL-USE (Ultra Simple Eq) is especially designed after some tilt eq's from the 70's. This type of eq allows to adjust the audio material without changing the character of a sound to much.
Its an easy way, to make an audio signal sound darker or brighter with only one knob. The bass lift knob is a special addition that boosts or attenuates bass frequencies below 300Hz.
TAL-Vocoder v1.2.0 :
TAL-Vocoder is a vintage vocoder emulation with 11 bands that emulates the sound of vocoders from the early 80’s. It includes analog modeled components in combination with digital algorithms such as the SFFT (Short-Time Fast Fourier Transform).
This vocoder does not make a direct convolution of the carrier and modulation signal as other digital vocoders maybe do. It includes an envelope follower for every of the eleven bands. This vocoder is optimized for voice processing and includes some algorithms for consonants to make the voice more intelligible.
The carrier signal is a VCO (Voltage Controlled Oscillator) with a Pulse, Saw, Noise and SubOsc. But it’s also possible to use the left stereo input as carrier. This way every sound source can be used as carrier signal. This plug-in supports every sample rate.
Free Products (SYNTH):
TAL-Bassline v1.5.5 :
TAL-BassLine is a virtual analog bass synthesizer especially made for bass, acid sounds and effects. It’s based on a robust core and has the usual controls of analogue hardware synthesizers.
A unique -18dB low pass filter with a lot of asymmetric and random components introduce a warm and analogue sound. Very fast, non linear envelopes are also a part of this synth.
TAL-Elek7ro-II v2.70 :
TAL-Elek7ro is a virtual analog synth with some special features like oscillator hardsync and frequncy modulation. Including improved alias free oscillators, new developed fast envelopes and lfo's with a wide range from 0.1Hz up to 400 Hz. A free routable envelope with attack and decay is available too. This synth is useful for a wide range of sounds from percusion to deep bass sounds.
TAL-NoiseMaker v4.1.0 :
TAL-NoiseMaker is an improved version of TAL-Elek7ro and has a completely new synth engine and a lot of improvements in sound and usability. The synth also includes a small effect section with a reverb, chorus and a simple bit crusher effect.
A display shows the knob and slider values. This allows more control over the synth. A ringmodulator and a syncable triangle are also part of this synth. TAL-NoiseMaker includes new filter types as the self resonating 6dB low pass and a notch filter. Its improved amplitude ADSR is very suitable for slow pads as for really fast envelopes.
TAL-U-NO-62 v1.80 :
TAL-U-NO-60 is a polyphonic virtual analogue synth with a unique filter sound. An original Juno-60 is used as reference for the oscillators and filters.
Like the original, the plugin is capable of self-resonance and thus could be used to some degree as a tone generator.
The filter section also features controls for envelope amount and polarity, LFO modulation and keyboard tracking. In addition, a non-resonant highpass filter is provided to thin out lower frequencies.

TAL Real Synth
http://www27. СПАМ Real Synth / Kunz & Knobel is a virtual analog mono synth.
Features:
• Low CPU usage.
• 2 band-limited oscillators (sinus, triangle, saw, square) and noise.
• FM, X-Mod, PW.
• 2 LFOs (sinus, triangle, saw, square), env mode.
• Mod AD envelope (OSC, FM, PW).
• Filter ADSR envelope.
• Amplitude ADSR envelope.
• Portamento.
• 24 dB resonance filter (lowpass, bandpass, highpass).
• 6 dB highpass filter.
• MIDI learn (all parameters).TAL Vintager
http://www27. СПАМ Vintager is a simple to use monophonic VST instrument with the functional range and sound of classic analog synths. A good sounding lowpass filter, three band-limited oscillators and accurate envelopes are the heart of this synth.
Features:
• Two oscillators with FM and PW (saw, pulse, triangle, sine, noise).
• One sub oscillator (rectangle, two octaves deeper).
• Low pass filter with self oscillation.
• Two precise non linear envelopes (filter, amplitude).
• Two LFOs with five different waveforms to modulate filter, pitch, FM and PW.
• Portamento (three different modes).
• MIDI learn for all pots.
• 20 presets (bass, leads, fx, percussion).
• All sample rates supported.
• Low CPU.